User Manual

ENG

Before placing the glass sump in the cabinet make sure that the cabinet

doors are correctly aligned (see instructions in the cabinet assembly

manual). Once the sump is in position it will not be possible to make

adjustments to the lower hinge without moving the sump.

With the doors properly aligned, rotate the front section of the push

opener to the correct extension so that the doors will pop open when

pushed.

Overflow box pipes: Make sure that that the O-rings are in position on the

threaded connectors before assembly. To ensure correct assembly, firmly

hold the threaded connectors from inside the cabinet and tighten well by

hand. Do not use tools. Avoid unscrewing the pipes from the overflow box

once assembled as the locking mechanism that prevents counter-rotation

will be less effective.

Sump pipes: Make sure that that the O-rings are in position on the

connectors before assembly. After assembly check that the pipes are

vertical and the securing nut is holding the pipe in position. Do not use

tools and do not overtighten.

Overflow Box Cover: The overflow box cover reduces noise from the water

fall of the surface skimmer. If you wish to use the rear wall of the overflow

box for mounting equipment such as lighting, break out the section of the

cover as shown in the graphic manual. After breaking out the removable

section, smooth the remaining edge with a file or sandpaper.

NOTE: The REEFER

™

aquarium system should not be moved when full

of water.