User's Manual

V7 EXTERNAL ANTENNA RTLS MODULE USER MANUAL

2) this device must accept any interference received, including interference that may cause

undesired operation.

5.5. ISED RSS-Gen Notice (in English and French):

This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the

following two conditions:

1) This device may not cause interference; and

2) This device must accept any interference, including interference that may cause

undesired operation of the device.”

“Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio

exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :

1) l’appareil ne doit pas produire de brouillage;

2) l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est

susceptible d’en compromettre le fonctionnement.

5.6. ISED Canada ICES-003 Compliance Label

CAN ICES-3 (B)/NMB-3(B)

5.7. RF Exposure Guidance

In order to comply with FCC / ISED RF Exposure requirements, this device must be installed to

provide at least 20 cm separation from the human body at all times.

Afin de se conformer aux exigences d'exposition RF FCC / ISED, cet appareil doit être installé

pour fournir au moins 20 cm de séparation du corps humain en tout temps.

5.8. Module integration instructions for the End-Product Manufacturer

The End-Product Manufacturer shall include the applicable items as appropriate for the radio

module:

1) List the FCC rules that are applicable to the modular transmitter (not part 15B)

2) Summarize any specific operational use conditions (power reduction

requirements/compensation for cable loss for point to point antennas, peak and min gain

per frequency band for 5GHz DFS master, professional use limitation-extends to host

manufacturers instruction manual)

3) RF exposure considerations: (1) for the host product manufacturer and (2) for the end

user

4) Antennas - A list of antennas included; identify types

5) Label and compliance information – advise host manufacturers to provide a physical / e-

label stating, “Contains FCC ID: 2ADX4-MDEV7”. “Contains IC: 12677A-MDEV7” with

their finished product

6) Information on test modes and additional testing requirements – how to configure test

modes for host product testing