User Manual

12
Kill Dry is not intended for typical serial eects routing or amp eects loops. The dry signal will be mut-
ed at all times. The BLEND knobs acts as an output level control.
Analog + FX Level is useful when placing Tensor as a looper at the beginning of your signal chain, if you
want to always pass the dry signal through to the rest of your pedals. It can also avoid phase issues in
parallel eects chains, since the dry signal has no latency. The BLEND knobs acts as an output level
control.
The bypass mode can be changed using MIDI System Exclusive (SysEx) messages, or via the TouchOSC
template we provide.
Setting MIDI channel
The Tensor transmits and receives on MIDI channel 1 by default. The MIDI channel can be changed using
MIDI System Exclusive (SysEx) messages, or via the TouchOSC template we provide.
Reset to Factory Defaults
Use the following procedure to reset the Tensor’s configuration data to factory default settings. This will
erase any advanced configuration and control port settings, but presets will not be aected.
Factory reset is useful if you purchase a used pedal or want to reset the configuration settings to their
default values without using the web editor.
1. With the pedal unplugged, set the HOLD and DIR switches to their “down” positions.
2. Hold the ON footswitch while plugging in power. The right LED will be solid white.
3. Move the HOLD and DIR switches to their “up” positions.
4. The left LED will blink green with the right solid blue.
5. When the factory reset is complete, both LEDs will cycle through all colors.
6. Power cycle the pedal to continue.