User Manual

Table Of Contents

Harmonic A440 (Hz) Pitch Shift + perfect ﬁfth Frequency Shift + 220 Hz

5th harmonic 2200 3300 2420

The shift left/right balance ([ALT]-SHIFT) control will keep the left (CCW) or right (CW) delay shift con-

stant while reducing and then inverting the shift of the other delay. Turning the control counter-clock-

wise will keep the left shift constant while reducing, disabling, and then inverting the right delay shift.

Turning the control clockwise will keep the right shift constant while reducing, disabling, and then in-

verting the left delay shift. At the minimum and maximum settings, the delays will be shifted in opposite

directions. The SHIFT control will aect both channels proportionally.

Frequency shifting creates similar sounds as ring modulation, but all of the new components are either

above or below the original frequency. Ring modulation adds new components above and below the

original. You can get a ring modulation eect by setting the shift left/right balance to its minimum or

maximum value and using a series delay structure or mono output.

Blend Controls

The BLEND control adjusts the wet/dry blend from 100% dry to 100% wet. The dry signal level is at full

volume until approximately 12:00.

[ALT]-BLEND adjusts the left/right balance of wet/dry levels. At 12:00, the left and right delay outputs

use the same wet/dry blend. Turning counter-clockwise, the left delay output remains at the BLEND

control setting and the right delay output level is reduced. Turning clockwise, the right delay output re-

mains at the BLEND control setting and the left delay output level is reduced. When a left/right balance

is set, the BLEND control will aect both delay outputs proportionally; the favored delay will follow the

BLEND control, and the other delay will get proportionally quieter.

If you prefer a unity-gain analog dry signal with the BLEND control acting as an eect level, use the edi-

tor to select Analog + FX Level bypass mode.