User Manual
Table Of Contents
12
Raster 2 Controls
Controls are identified by their front panel labels in BOLD. Alternate controls are labeled in gray, and are
related to the primary (blue) control label. They are saved to presets and remembered when the pedal is
turned o. Each each knob's alternate function is related to its primary function and the default setting
is 12:00 (center).
To adjust alternate parameters, hold the WAVE/[ALT] pushbutton until the right LED turns cyan. For left/
right controls (labeled "L / R"), the PRESET and WAVE LEDs will show the setting as the knob is moved.
Left/right controls are o when the two middle LEDs are lit:
○○○● ●○○○ Indicates left/right control is off.
Almost all of the Raster's functionality is available on the front panel, but a few parameters are only
available by using MIDI, the web editor, or other editors. Those features are marked with a MIDI port
symbol. Editor/MIDI-only parameters are saved in presets and remembered when power is turned
o.
On / Bypass
Press the right footswitch to switch the Raster between enabled and bypass.
On indicator (right LED)
O Bypass
Red On
Cyan Editing secondary controls
Yellow (blink) Tap tempo
MIDI clock
Green (blink) Preset saved
CTRL config saved
M Momentary Eect is active while the footswitch is held down, and switches to bypass as
soon as it is released.
L Latching Pressing the footswitch alternates between active and bypass.
ø Mute Output Pressing the footswitch alternates between active and bypass. In bypass, the
output is muted and the pedal continues recording the input signal.
Trails are disabled.
Mute Output allows you to repeat or loop what you previously played (based on the delay length). To
loop what you just played, set the FDBK knob to the ∞ position and set the delay time to the length of
the loop. When you have played a phrase that you want to repeat, turn the pedal on and it will loop. To