User Manual
Table Of Contents
9
[DIV] sets grain density (interonset time) or LFO to a note division, depending on mode.
Bypass
The right footswitch turns the eect on and o. Tap to toggle between bypass and eect. From bypass,
pressing and holding the footswitch will engage the eect momentarily and return to bypass when you
release.
The Particle remembers its bypass state when power is removed.
Hold down the right footswitch while plugging an expression pedal, CV cable, or remote switch into the
CTRL port to configure the port. See "Control input (expression pedal)" on page 15 for details.
You can also hold down the right footswitch to adjust tap tempo note divisions ([DIV]) and hidden param-
eters. See "" on page 18, and the following sections.
Trails
Turning on trails will cause the eect to decay naturally after the eect is switched to bypass. You can
turn trails mode on or o using our web-based editor or MIDI CC #111. The trails mode is saved when
the Particle is turned o, and is saved in presets.
Freeze
When the CHOP knob is above 12:00, it sets the amplitude threshold for freezing the current delay buer.
Holding the TAP/FREEZE (left) footswitch will momentarily turn on freeze mode. The bypass LED chang-
es from blue to cyan while freeze is active.
The Particle has two dierent freeze modes:
• grain freeze (default): the delay buer is frozen
• delay freeze (v1): the delay output is recycled
You can change the freeze mode via MIDI or our web editor. It is stored in presets, and will be remem-
bered when power is o.
Grain freeze
The delay buer is frozen, allowing you to scrub through the frozen audio without degrading the sound.
The results vary depending on which mode is active:
• DELAY+DENS: repeats a slice of audio with length set by CHOP, DELAY scrubs through buer.
• DELAY+LFO: scrubs through buer at length set by PARAM.
• DELAY+REV: repeats a slice of audio with length set by CHOP, DELAY scrubs through buer.
• DELAY+PITCH: repeats a slice of audio with length set by CHOP, DELAY scrubs through buer.
• DELAY+RND: randomly jumps around buer.
• PITCH+DTUNE: repeats a slice of audio with length set by CHOP.
• PITCH+LFO: repeats a slice of audio with length set by CHOP.
• PITCH+DENS: repeats a slice of audio with length set by CHOP.