User Manual
Table Of Contents
- Introduction
- Signal Flow
- Getting Started
- Inputs and Outputs
- Controls
- Reverb Algorithms
- Bypass
- Trails
- Reverb Hold (∞)
- Drone Mode
- HI / LO Response
- Tremolo (Spring Only)
- Dynamics
- Delay
- Presets
- Control Input
- Tap Tempo
- Using MIDI
- Reset to Factory Defaults
- Web Editor
- Support and Repairs
- Warranty
- Firmware Updates
- Specifications
- Credits
25
Reset to Factory Defaults
Use the following procedure to reset the Context's configuration data to factory default settings. This
will erase any advanced configuration and control port settings, but presets will not be aected. Sec-
ondary parameters will be reset to their default values and expression pedal will be assigned to DECAY.
1. With the pedal unplugged, set the mode switch to the ROOM position.
2. Hold the ON footswitch while plugging in power. The right LED will be solid white.
3. Rotate the mode switch to the GRAIN position.
4. Release the ON footswitch.
5. When the factory reset is complete, the LEDs will cycle through dierent colors.
6. Power cycle the pedal to continue.