User Manual
Table Of Contents
- Introduction
- Signal Flow
- Getting Started
- Inputs and Outputs
- Controls
- Reverb Algorithms
- Bypass
- Trails
- Reverb Hold (∞)
- Drone Mode
- HI / LO Response
- Tremolo (Spring Only)
- Dynamics
- Delay
- Presets
- Control Input
- Tap Tempo
- Using MIDI
- Reset to Factory Defaults
- Web Editor
- Support and Repairs
- Warranty
- Firmware Updates
- Specifications
- Credits
17
Use reverb expansion with a quick release to create unnatural reverb tails. Set the threshold right be-
low the point where the LED blinks red on note attacks. As notes decay, the reverb level will fall o more
rapidly.
Use expansion to emphasize loud chords, while applying more subtle reverb to melodies. Set the
threshold so that the LED is red during loud passages and green during quiet passages. The release
time controls how tightly it tracks your playing, and the reverb decay controls how long it lingers.
Use a volume pedal, volume knob, or pickup selector switch to move above and below the threshold,
putting a compressor after the Context to smooth out volume dierences.