User Manual

20
Testing the connection
To test the connection, tap Connect in the Network, Prefs screen.
Using the Internet
Now that the ISP and phone set up is complete, when you use an
application that requires an Internet connection, the Red-M Blade
will automatically contact the mobile phone which will dial your
ISP and give you an Internet connection.
Note: If you subsequently change the network service selected
on the System, Prefs, Network screen (for example, if you
change to Bluetooth Bt LAN Access service that uses a LAN
Access Point on a corporate Bluetooth network), when you want
to connect to your mobile phone, you must reset the current
network service to the Bluetooth Dial-up service that you added
in the above procedure.
To end the Bluetooth session
To end the Bluetooth session and thereby terminate the mobile
phone call, do one of the following:
• switch off the Palm Vx.
•use the Disconnect option (if one exists) in whichever
application you are using.
•go to System, Prefs, Network and tap the Disconnect button.
8. Set up your ISP details:
i. Select Network, then tap the Menu icon
and tap New.
ii. Give the Service a name - ‘Freeserve’ for
example - and under User Name input the
name required by your ISP.
iii. Tap -Prompt- to enter the ISP password;
if you leave the password setting as
-Prompt- you will be asked to input the
password each time you connect.
iv. Set Connection as Bt Dial-up using the
drop-down list.
v. Enter the ISP phone number in Phone.