User Manual

Red-M Blade - Bluetooth Clip-on for Palm Vx User Guide
19
To configure your Palm Vx to connect to a
mobile phone
Note: Depending on the manufacturer, you may need to
configure your mobile phone to be Bluetooth-enabled. Refer to
the documentation that accompanied it for more information.
1. On your Palm Vx handheld, perform a device
discovery:
i. Go to System, Prefs and select Bluetooth
from the pick list.
ii. Tap 2 ( ) to go to Screen 2 (shown);
ensure that the pick list selection is set to
All or Unfiled, and then tap Discover.
iii. The Red-M Blade will then find all
Bluetooth-enabled devices in range.
iv. Tap Stop to halt the discovery process.
2. Look for the Bluetooth address or name of
your mobile phone in the list of discovered
devices. Tap on this address or name to go
to the Device Information dialog (shown).
3. In the Device Information dialog, tap
-Not set- and enter the passkey of your
mobile phone. Tap OK to close the Bluetooth
Passkey dialog.
4. Tap Update. The Red-M Blade will retrieve
the device name and service profiles
available; a tick should now be displayed
beside Dial-up Networking.
5. Tap OK to exit the Device Information dialog
and return to the list of discovered devices.
6. Move your mobile phone into the Phones
category:
i. Tap the checkbox to the left of the name
of your mobile phone.
ii. Tap Move; in the Move Selected Devices
dialog, select Phones from the drop-down
menu. Tap OK to accept the change and
close the dialog.
7. Tap 1 to go to Screen 1; ensure that the
Dial-up category is set to Phones.