User Manual

Red-M Blade - Bluetooth Clip-on for Palm Vx User Guide
15
2. Look for the Bluetooth address or name of
your mobile phone in the list of discovered
devices. Tap on this address or name to go
to the Device Information dialog (shown).
3. In the Device Information dialog, tap
-Not set- and enter the passkey of your
mobile phone. Tap OK to close the Bluetooth
Passkey dialog.
4. Tap Update. The Red-M Blade will retrieve
the device name and service profiles
available; a tick should now be displayed
beside Dial-up Networking.
5. Tap OK to exit the Device Information dialog
and return to the list of discovered devices.
6. Move your mobile phone into the Phones
category:
i. Tap the checkbox to the left of the name
of your mobile phone.
ii. Tap Move; in the Move Selected Devices
dialog, select Phones from the drop-down
menu. Tap OK to accept the change and
close the dialog.
7. Tap 1 to go to Screen 1; ensure that the
Dial-up category is set to Phones.
8. Set up your ISP details:
i. From the pick list in the top right-hand
corner, select Network, then tap the Menu
icon and tap New.
ii. Give the Service a name - ‘Freeserve’ for
example - and under User Name input the
name required by your ISP.
iii. Tap -Prompt- to enter the ISP password;
if you leave the password setting as
-Prompt- you will be asked to input the
password each time you connect.
iv. Set Connection as Bt Dial-up using the
drop-down list.
v. Enter the ISP phone number in Phone.