User Guide

Initial Configuration
The first time you access the 950AP’s management interface, you
need to set the administrator password, specify how IP addresses will
be assigned and set the security level on the Initial Configuration
screen. You can complete this with an Ethernet connection or
wirelessly using Bluetooth.
Figure 5: Initial Configuration screen
Initial Configuration for corporate installation
1. Enter a name for the 950AP if you want to easily recognize it.
2. Enter an administrator password (16 characters maximum) and
then confirm the password.
3. Enable/disable Network Address Translation (NAT) for the
950AP. By default NAT is enabled. Clear the checkbox if you do
not need to use NAT.
4. Select the WAN port (Network port) configuration:
-Select DHCP if your 950AP receives its IP addresses from a
DHCP server. If you select DHCP and turn NAT off, the
950AP uses the DHCP server for its WAN port IP address and
to assign IP addresses to Bluetooth devices.
-Select Static if you use static IP addresses. If you select
Static and turn NAT off, enter the Static IP Parameters on
page 2, including at least seven addresses in the Bluetooth
address pool (see Figures 6 and 7). The addresses must be
on the same IP network as your LAN but must not conflict
with existing addresses.