User Manual

Red-M 1000AP getting started guide
13
Configuring 1000APs
1000APs automatically appear in the Genos
management interface when they are installed,
connected and powered-up. 1000APs are displayed in
the AP List dialog. By default, they are listed by their
name and serial number, which is printed on the base of
the unit.
1000APs are automatically enabled through the
management interface. Therefore, you do not need to do
anything to use 1000APs, however, you may want to
change the default settings. You can configure 1000APs
when their LED is steady red.
To edit the 1000AP’s configuration
1. Log on to the management interface as an
administrator from a management PC.
2. The AP List dialog displays with all connected access
points. If a 1000AP is missing from this list, wait a
few minutes and check the unit: its LED may be
flashing red to indicate that it has not connected
properly, or it may be steady orange to indicate a
fault. (See Reading the LED on page 15 for more
information.)
3. Click on a 1000AP’s name or hardware address to
open the AP Stats dialog, which shows information
about that unit.
4. Click on AP Record to open the Bluetooth AP Edit
dialog. In this dialog, you can rename the 1000AP,
assign it to a group, enable or disable 1000AP
aerials, enter Security settings and set available
Bluetooth Services.
Tip: You can click a 1000AP’s record icon in the AP
List to directly access a Bluetooth AP Edit dialog.