Instruction Manual

-85-
APPENDIX “F” - USER PARAMETER VALUE CHART
Unit Number
Mnemonic Parameter User Setting
SP Temperature Setpoint
OPOF Output Power Offset
OP Output Power
ProP Proportional Band
Intt Integral Time
dErt Derivative Time
AL-1 Alarm 1
AL-2 Alarm 2
Configure Input
tYPE Input Sensor Type
SCAL Temperature Scale Units
dCPt Temperature Resolution
FLtr Digital Filtering
SPAN Input Slope
SHFt Input Offset
SPLO Setpoint Lower Limit
SPHI Setpoint Upper Limit
SPrP Auto Ramp Rate
InPt User Input
Configure Output
CYCt Cycle Time
OPAC Control Action
OPLO Output Power Lower
Limit Range
OPHI Output Power Upper
Limit Range
OPFL Sensor Fail Power Preset
CHYS ON/OFF Control Hysteresis
tcod Auto-Tune Damping Code
ANAS Linear Output Assignment
ANLO Linear Output Scale Value
ANHI Linear Output Scale Value
Configure Lockouts
Mnemonic Parameter User Setting
SP Access Setpoint
OP Access Output Power
P-cs Access Profile Status
P-tr Access Time Remaining
UdSP Access Display Units
Code Access Code Number
PID Access PID Values
AL Access Alarm(s) Values
ALrS Enable Reset Alarm(s)
CPAC Enable Control Points
PrAC Enable Profile Status
trnF Enable Auto/Man Transfer
tUNE Enable Auto-Tune
Configure Alarms
Act1 Alarm 1 Operation Mode
rSt1 Alarm 1 Reset Mode
Stb1 Alarm 1 Standby Enabled
AL-1 Alarm 1 Value
Act2 Alarm 2 Operation Mode
rSt2 Alarm 2 Reset Mode
Stb2 Alarm 2 Standby Enabled
AL-1 Alarm 2 Value
AHYS Alarm Hysteresis Value
Configure Cooling
CYC2 OP2 Output Cycle Time
GAN2 Relative Cooling Gain
db-2 Heat-Cool Overlap/Deadband
Configure Serial Communications
Mnemonic Parameter User Setting
bAUd Baud Rate
PArb Parity Bit
Addr Unit Address
Abrv Abbrev. or Full Transmission
PrAt Automatic Print Rate
PoPt Print Options
INP
SEt
OPr
Pdb
INt
dEr
AL1
AL2
dEv
OFP
rP
Crg
Cdb
P-t
P-s