User Manual

1515
6.3 MODULE 3 - DISPLAY AND PROGRAM LOCK-OUT
PARAMETERS ()
3-LOC
SP-n COdE
Totalizer x
Display
Lockout
Totalizer x
Scale Factor
Access
Totalizer A
Count Load
Access
rAtE
Rate x
Display
Lock-out
PAR
tot ACntLd SCFAC
Pro
Setpoint 1-4
Access
Security
Code
xx
x
Totalizer B
Count Load
Access
bCntLd
PARAMETER MENU
x = Rate or Totalizer A, B, and then C
 = Setpoints 1 to 4
Module 3 is the programming for Display lock-out and “Full” and “Quick”
Program lock-out.
When in the Display Mode, the available displays can be read consecutively
by repeatedly pressing the DSP key. An annunciator indicates the display being
shown. These displays can be locked from being visible. It is recommended that
the display be set to  when the corresponding function is not used.
SELECTION DESCRIPTION

Visible in Display Mode

Not visible in Display Mode
“Full” Programming Mode permits all parameters to be viewed and
modified. This Programming Mode can be locked with a security code and/or
user input. When locked and the PAR key is pressed, the meter enters a Quick
Programming Mode. In this mode, setpoint, count load and scale factor values
can still be read and/or changed per the selections below. The Display Intensity
Level () parameter also appears whenever Quick Programming Mode is
enabled, and the security code is greater than zero.
SELECTION DESCRIPTION

Visible but not changeable in Quick Programming Mode

Visible and changeable in Quick Programming Mode

Not visible in Quick Programming Mode




RATE A B C DISPLAY LOCK-OUT
TOTALIZER A B C DISPLAY LOCK-OUT
These displays can be programmed for  or .




















The setpoint values can be programmed for , , or . Accessible
only with a Setpoint Plug-in card installed.




SETPOINT 1 to 4 ACCESS LOCK-OUT












to
Count Load values can be programmed for , , or .
TOTALIZER A and B COUNT LOAD ACCESS LOCK-OUT








The Scale Factor values can be programmed for , , or .




TOTALIZER A B C SCALE FACTOR ACCESS LOCK-OUT




Entry of a non-zero value will cause the prompt  to appear when trying to
access the “Full” Programming Mode. Access will only be allowed after entering
a matching security code or universal code of
. With this lock-out, a user input
would not have to be configured for Program Lock-out. However, this lock-out is
overridden by an inactive user input configured for Program Lock-out.
SECURITY CODE








PROGRAMMING MODE ACCESS
Throughout this document, Programming Mode always refers to “Full” Programming (all meter parameters are accessible), unless “Quick
Programming” is referenced.
SECURITY
CODE
USER INPUT
CONFIGURED
USER INPUT
STATE
WHEN PAR KEY IS
PRESSED
“FULL” PROGRAMMING MODE ACCESS
0
not 
———— “Full” Programming Immediate access.
>0
not 
———— Quick Programming w/Display Intensity After Quick Programming with correct code # at  prompt.
>0

Active Quick Programming w/Display Intensity After Quick Programming with correct code # at  prompt.
>0

Not Active “Full” Programming Immediate access.
0

Active Quick Programming No access
0

Not Active “Full” Programming Immediate access.