Manual

Software User Guide 91
Services Tab
• Todeleteanaddress,selectitinthetableandclickontheDeletebutton.Toeditanexistingrule,selectitinthe
tableandclickontheEditbutton.
• Clickonthe“Save”buttonforchangestobesave dwithoutactivatingtheinterfaceuntilyoureboottheunit,
the
“Apply ” buttonwillsaveyoursettingsandapplythemimmediately.Toreverttothepreviousdefaults,clickonthe
“Revert”button.
3.5.2 DHCPRelay
ThisfeaturewillenableaDHCPRelayservice,whichwillconnectalocalinterfacewitharemoteDHCPServer.DHCPRelay
shouldnotbeenabledforanyinterface(s)whichhavebeenconfiguredtoactasaDHCPserver.
• ClickonDHCPRelayandthefollowingdialogwindowwillappear:
EnableDHCP
Relay:SelectYEStoenabletheDHCPRelay ,orNOtodisableit.TheservicewillstartoncetheApplybut‐
tonisclicked.IftheSavebuttonisclicked,theservicewillnotbestarteduntilthedeviceisrebootedandthenonly
if
theStartatboottimeoptionhasalsobeensettoYES.
Startatboottime:SelectYEStoenabletheDHCPRelayatboottime,orNOformanualcontrol.IftheDHCPRelayser‐
viceisrequiredtobeoperationalatalltimes,thensettoYES.If
anotherprocess,suchasVRRP,isgoingtodynamically
enable/disableDHCPRelayserviceasneeded,thensettoNO.