User guide

APPENDIX “D” - GEMINI 3300 BATCH COUNTER MODE FUNCTION COMMAND CODE SUMMARY
-38-
CODE MODE DESCRIPTION COMMENTS
41 LOAD FACTORY SETTINGS
+/- Batch Counter (-) Loads factory set code values*
43 INPUTS A & B RESPONSE MODES (counter only)
1 Count with Inhibit Input A = Count, Input B = Inhibit
2 Count with Up/Down Control Input A = Count, Input B = Up/Down
3 Add/Subtract Input A = Add, Input B = Subtract
4 Anti-Coincidence Add/Add Input A = Add, Input B = Add
5 Quadrature Input A = Count, Input B = Quadrature
6 Quadrature x4 Input A = Count & Quad, Input B = Count & Quad
44 NUMBER OF COUNT EDGES Cannot be programmed in Quad x4.
1 Single Edge Counting (x) 1 Count on falling edge of count input.
2 Double Edge Counting (x2) Count on both edges of count input.
45 SCALE MULTIPLIER
11
20.1
30.01
4 0.001
46 DECIMAL POINT & LEADING ZERO BLANKING
- (+) Leading Zero Blank Enabled
- (-) Leading Zero Blanking Disabled *
+/-1 No Decimal Point
+/-2 Decimal Point Right of Digit 2
+/-3 Decimal Point Right of Digit 3
+/-4 Decimal Point Right of Digit 4
+/-5 Decimal Point Right of Digit 5
+/-6 Decimal Point Right of Digit 6
*Polarity sign is displayed in front of the identifier, a (-) sign is displayed, a (+) sign is not.