Operating instructions

Additional information
08
51
En
Cannot play multi-
channel audio
• Make sure that Audio Output Mode is set to 5.1 Channel
(page 41).
• Check that the Dolby Digital, DTS and MPEG Out settings
(pages 35–36) are suitable for your amplifier/receiver—check the
instruction manual that came with your amplifier/receiver.
• DVD-Audio and SACDs do not output multichannel digital audio.
Listen through the player’s analog outputs.
• Check that the settings in the Speaker Installation screen are
correct (page 42).
• Check the audio options available from the disc menu.
Cannot listen to high-
sampling rate audio
through the digital
output.
• Make sure that Linear PCM Out is set to Downsample Off
(page 35).
• As a copy-protection measure, some DVDs do not output 96kHz
audio. In this case, even if set to Downsample Off , the player
automatically outputs the audio at 48 kHz. This is not a malfunction.
Cannot output 192kHz or
176.4kHz digital audio.
• The player does not output digital audio at these sampling rates. The
digital output is automatically downsampled.
Cannot output 96kHz or
88.2kHz digital audio.
• Check that Linear PCM Out is set to Downsample Off (page 35).
• Some discs are digital copy protected and do not output high
sampling rate digital audio. In this case the output is automatically
downsampled.
No DTS audio output. • If this unit is connected to a non-DTS compatible amplifier or
decoder using a digital audio cable, set DTS Out to DTS
>
PCM
(page 35). If you do not do this, noise will be output when you play a
DTS disc.
• If this unit is connected to a DTS-compatible amplifier or decoder
using a digital audio cable, check the amplifier settings, and that the
cable is properly connected.
Audio mix does not
sound right or sounds
incomplete (for example,
inaudible dialog).
• Make sure that Audio Output Mode is set to 2 Channel if you've
connected to the stereo inputs on your amplifier or TV (page 41).
The audio recorded on a
Super VCD disc is not
output properly.
• If the audio is switched to [2] when playing a Super VCD that
contains only one stereo soundtrack, there may be no sound at all.
Press AUDIO to change the soundtrack.
Can’t hear effect of
Virtual Surround
• Virtual Surround does not work with SACD or DVD-Audio.
• The Virtual Surround effect is only output through the AUDIO OUT
(2ch) analog audio outputs.
• Make sure that Audio Output Mode is set to 2 Channel (page 41).
• The effectiveness of Virtual Surround varies with the disc.
Problem
Remedy
DV575A KU_Mid.book 51 ページ ２００４年２月６日 金曜日 午後２時３８分