Installation Instructions

or go to the
Advance Search
Search
Multi
-
Set II Drop
-
In Anchor
Installation Instructions
Product Information
:
Suggested Specifications
Selection and Order Information
:
Performance Data
:
Approvals and Listing
INSTALLATION STEPS
To set anchor flush with surface:
1.
Drill hole to required embedment (
see Table
).
2.
Clean hole with pressurized air.
3.
Drive anchor flush with surface of concrete .
4.
Expand anchor with setting tool provided (
see chart
). Anchor is
properly expanded when shoulder of setting tool is flush with top of
anchor.
To set anchor below surface:
Drill hole deeper than anchor length. Thread bolt into anchor. Hammer
anchor into hole until bolt head is at desired depth. Remove bolt and set
anchor with setting tool.
APPLICATIONS
Pumps and heavy piping are common
applications for larger diameter Multi
-
Set Drop
-
In
Anchors.
Cable tray and strut suspended from concrete
ceilings are ideal Multi
-
Set applications. In post
-
tension or hollow
-
core slabs use the RX
-
38
ITW Red Head Multi Set II Installation Instructions