User`s guide

8
Figure 30 Installing enclosure retention clipnuts in an HP Computer
Cabinet 61
Figure 31 Installing the storage device in an HP Computer Cabinet 62
Figure 32 Installing a filler panel in an HP Computer Cabinet 63
Figure 33 Rittal-Style Rail Kit Contents 64
Figure 34 Rail Alignment 65
Figure 35 Front Screw Installation 66
Figure 36 Rear Slide Extension 67
Figure 37 Center Nut Tightening 67
Figure 38 Installing a Disk System into the Rittal-Style Rack 68
Figure 39 Moving a Disk System Retention Bracket 69
Figure 40 Bolting the Disk System to the Front Column of the Rack 69
Figure 41 BCC Installation 72
Figure 42 BCC Filler Panel 73
Figure 43 BCC DIP Switches 74
Figure 44 Wiring Scheme for 1.6-Meter Rack 76
Figure 45 Wiring Scheme for 2.0-Meter Rack 77
Figure 46 Disk Module Installation 78
Figure 47 On/Off Switch and System LEDs 80
Figure 48 DIP Switches 86
Figure 49 Disk Module Slots and SCSI Addresses 89
Figure 50 Sample Hardware Event Notification 99
Figure 51 LED Status Indicators 101
Figure 52 Disk System Field Replaceable Units (FRUs) 108
Figure 53 Disk Module Removal 117
Figure 54 BCC Removal and Replacement 120
Figure 55 BCC DIP Switches 121
Figure 56 BCC Filler Panel Installation 122
Figure 57 Power Supply Removal and Replacement 124
Figure 58 Disk System Removal and Replacement 126
Figure 59 Top Cover Assembly 129
Figure 60 Midplane Assembly 132
Figure 61 End Cap Removal and Replacement 134
Figure 62 Base Removal and Replacement 135
Figure 63 Base Removal from Chassis 136
Figure 64 Removal from Cover 137
Figure 65 Installing Disk System into Cover 138
Figure 66 Installing Base to Cover and Chassis 139
Figure 67 End Cap Replacement 140