Installation guide

Table A.63. Red Hat Satellite::Disk Space set tings
Field Value
Device Pathname* /dev/hda1
Critical Maximum File System Used
Warning Maximum File System Used
Critical Maximum Space Used
Warning Maximum Space Used
Critical Maximum Space Available
Warning Maximum Space Available
A.10.2. Red Hat Satellite::Execution Time
The Red Hat Satellite::Execution Time probe monitors the execution time for probes run from a Satellite
and collects the following metric:
Probe Execution T ime Average - The seconds required to fully execute a probe.
Table A.64 . Red Hat Satellite::Execution Time settings
Field Value
Critical Maximum Probe Execution T ime Average
Warning Maximum Probe Execution T ime Average
A.10.3. Red Hat Satellite::Interface Traffic
The Red Hat Satellite::Interface Traffic probe monitors the interface traffic on a Satellite and collects the
following metrics:
Input Rate - The amount of traffic in bytes per second the device receives.
Output Rate - T he amount of traffic in bytes per second the device sends.
Table A.65. Red Hat Satellite::Int erface T raffic settings
Field Value
Interface* eth0
Timeout (seconds)* 30
Critical Maximum Input Rate
Critical Maximum Output Rate
A.10.4. Red Hat Satellite::Latency
The Red Hat Satellite::Latency probe monitors the latency of probes on a Satellite and collects the
following metric:
Probe Latency Average - The lag in seconds between the time a probe becomes ready to run and
the time it is actually run. Under normal conditions, this is generally less than a second. When a
Satellite is overloaded (because it has too many probes with respect to their average execution time),
the number goes up.
Probes
125