Installation guide

62  Websense Installation Guide
Chapter 3: Upgrading Websense Enterprise or Web Security Suite
5. Run the Websense installer from the directory where you unpacked it
using the following command:
./install.sh
To run the GUI version of the installer, use the following command:
./install.sh -g
If you are using a non-English based system, the installer will display an
error message advising you that the GUI version is not supported.
6. Make the following selections:
 Stand-Alone Edition Detected: The installer detects the presence of
the Websense Stand-Alone Edition and asks what you want to do.
Select Integrate with a firewall, proxy server, or network
appliance and continue.
 Stopping Websense services: A message explains that the installer
must stop the Filtering Service before the installation can proceed.
Select Next to continue.
 Integration product: Select Sun Java System Web Proxy Server
from the list of supported integration types.
 Sun Java System configuration: The installer asks for configuration
information for the Sun Java System Web Proxy Server:
• Enter the location of the configuration file for the Sun Java System
Web Proxy Server (
obj.conf). This file is located in the
/config subdirectory in the directory where the Web Proxy
Server instance associated with the Websense filtering software
was installed. Installation of the Sun Web Proxy Plug-in modifies
this configuration file for communication with the Websense
Filtering Service.
• Select the version number of your Sun Java System Web Proxy
Server.
 System requirements check: The installer compares the system
requirements for the installation you have selected with the resources
of the installation machine. If the machine has inadequate disk space
or memory, separate warnings are displayed.
• If the installation machine has insufficient disk space, the selected
components cannot be installed, and the installer will quit.