Installation guide

176  Websense Installation Guide
Chapter 4: Installing Websense Enterprise or Web Security Suite
3. Run the following program from the Websense installation directory
(default is
/opt/Websense):
./uninstall.sh
Run the GUI version of the installer with the following command:
./uninstall.sh -g
If you are using a non-English based system, the installer will display an
error message advising you that the GUI version is not supported.
The installer detects the currently installed Websense components and
displays a list of installed components. By default, all components are
selected for removal.
4. Make sure that only the components you want to remove are selected, and
then select Next to continue.
 Policy Server status: If the Policy Server is not running, a dialog box
appears advising you that removing Websense components may
require communication with the Policy Server. You may exit the
installer to restart the Policy Server, or continue uninstalling the
selected components.
 Summary list: A summary list of the components you have selected
to remove appears. Select Next to remove these components.
Warning
Do not uninstall the Policy Server without uninstalling all
of the Websense components. Removing the Policy Server
will sever communication with the remaining Websense
components and will require the reinstallation of those
components.
Warning
If the Policy Server is not running, the files for the selected
components will be removed, but not the information
about the components recorded in the
config.xml file.
This could cause problems if you decide to add these
components again at a later date.