Installation guide

158  Websense Installation Guide
Chapter 4: Installing Websense Enterprise or Web Security Suite
To install the Remote Filtering Server on a Solaris or Linux machine:
1. Download and start the installer using the procedure in Solaris and Linux
Procedures, page 142.
2. Following the Custom installation path brings you to a list of components
to install. Select Remote Filtering Server.
If the installation machine is multihomed, all enabled network interface
cards (NICs) with an IP address are displayed.
3. Select the IP address of the card you want the Remote Filtering Server to
use to communicate with other Websense components inside the network
firewall, and then select Next to continue.
Remote Filtering Clients must be able to connect to the Remote Filtering
Server, both from inside and from outside the internet gateway or network
firewall. The installer asks you to provide connection information for this
machine.
4. In the External IP Address or Host Name field, enter an IP address or
machine name (in the form of a fully qualified domain name) that is
visible from outside the firewall.
Important
 Install only one primary Remote Filtering Server for
each Filtering Service in your network.
 Do not install the Remote Filtering Server on the same
machine as the Filtering Service or Network Agent.
 Do not enable DHCP on the Remote Filtering Server
machine.