Installation guide

Sun Java System Web Proxy Server  151
Chapter 4: Installing Websense Enterprise or Web Security Suite
If the installation machine is multihomed, all enabled network interface
cards (NICs) with an IP address are displayed.
3. Select the IP address of the card you want RADIUS Agent to use to
communicate.
The installer asks you to identify the machine on which the Policy Server
is installed.
4. Enter the IP address of the Policy Server machine, and the port number if
different from the default, and then select Next to continue.
The installer asks you for the location of the installation directory.
5. Enter the path to the installation directory, or accept the default Websense
installation directory (
/opt/Websense). If this directory does not
already exist, the installer will create it.
The installer compares the system requirements for the installation you
have selected with the resources of the installation machine. If the
machine has inadequate disk space or memory, separate warnings are
displayed.
 If the installation machine has insufficient disk space, the selected
components cannot be installed, and the installer will quit.
 If the installation machine has less than the recommended amount of
memory, the installation can continue. To ensure the best performance
of the components you are installing, you should upgrade your
machine’s memory to the recommended amount.
A summary of all the components that will be installed appears.
Note
The displayed configuration port (55806) is the default
port number used by the installer to install the Policy
Server. If you installed the Policy Server using a different
port number, enter that port number.
Important
The full installation path must use only ASCII characters.
Do not use extended ASCII or double-byte characters.