Installation guide

138  Websense Installation Guide
Chapter 4: Installing Websense Enterprise or Web Security Suite
Below are the necessary command line parameters for installing the Remote
Filtering Client with a third-party deployment tool:
 The following parameters must be configured to allow the Remote
Filtering Client to communicate with the primary Remote Filtering
Server:
 PRIMARY_WISP_ADDRESS=<external IP address or FQDN of
primary Remote Filtering Server>
The externally visible address for the primary Remote Filtering
Server machine, as entered in the External IP Address or Host
Name field when the primary Remote Filtering Server was installed.
 PRIMARY_WISP_PORT=<external port number of primary Remote
Filtering Server
>
The port number for the externally visible port used to communicate
with the primary Remote Filtering Server from outside the network
firewall. This must be the same port entered in the External
Communication Port field when this Remote Filtering Server was
installed.
 PRIMARY_INTERNAL_WISP_ADDRESS=<internal IP address or
FQDN of primary Remote Filtering Server>
The internal address, visible from inside the network firewall, for the
machine on which the primary Remote Filtering Server is installed.
Note
These parameters are not case sensitive.
Important
This must be the same external address in the same
address format—IP address or FQDN—that was entered
when this Remote Filtering Server was installed. That is, if
you entered an IP address in the External IP Address or
Host Name field when installing the Remote Filtering
Server, you must enter the same IP address here. If you
entered a machine name in the form of a fully qualified
domain name (FQDN), you must enter the same FQDN
here.