Installation guide

108  Websense Installation Guide
Chapter 4: Installing Websense Enterprise or Web Security Suite
If you are attempting to install Network Agent on a machine on which the
Filtering Service and Policy Server are already installed, see the procedures in
Adding Components, page 162.
To install Network Agent on a Windows machine:
1. Download and start the Windows installer using the procedure in
Windows Procedures, page 101.
2. Following the Custom installation path brings you to the component
selection screen. Select Network Agent and click Next.
The installer asks you to identify the machine on which the Policy Server
is installed.
3. Enter the IP address of the Policy Server machine, and the port number if
different from the default, and then click Next.
The installer asks you if this machine is running a firewall. Make sure that
the installation machine is not being used as a firewall before continuing.
Important
The Websense Filtering Service and the Policy Server
must be installed and running prior to installing Network
Agent, or installed at the same time as Network Agent.
The installer asks for the IP addresses and port numbers of
these components and will not install Network Agent if the
Policy Server and Filtering Service cannot be located.
Note
The configuration port (55806) in this dialog box is the
default port number used by the installer to install the
Policy Server. If you installed the Policy Server using a
different port number, enter that port number in this dialog
box.