Installation guide

142 Chapter 14. Frequently Asked Questions

Figure 14-1. The Opening Dialog of XConﬁgurator

To navigate and make selections, use the [Tab] key. When your selection is highlighted, press the

[Enter] key.

Note

Make certain that your monitor and graphics card are supported for Red Hat Linux. To check, visit

the Hardware Compatibility List at http://hardware.redhat.com.

To continue, [Tab] until the Ok button is highlighted and press [Enter]. Xconﬁgurator will then probe

your system for your video card, and suggest the correct X server to match your system, as in Figure

14-2. Click the Ok button to proceed.

Figure 14-2. Results of Video Card Probe

Next, pick your exact monitor make and model number, as in Figure 14-3. You can often ﬁnd the

make and model number on the front or back of your monitor.