Installation guide

48 Chapter 2. Kickstart Configurator
2.5. Network Configuration
Figure 2-6. Network Configuration
There are three network configuration options: DHCP, Static IP, and None. If there is not an
Ethernet card in the system, choose None.
Networking is only required if you choose a networking-type installation method (NFS or
FTP). If you are unsure which to choose, choose None. Networking can always be configured
after installation with the Red Hat Network Configurator using the command (redhat-
config-network.
If you select Static IP, you must provide additional networking information in the table
below the network types.