Technical data

Brocade Network Advisor SAN Installation and Migration Guide 51
53-1003580-01
Cross flavor migration
3
14. Complete the following steps on the Start Server screen.
a. (Trial and Licensed only) Select the Start SMI Agent check box, if necessary.
b. (Trial and Licensed only) Select the Start SLP check box, if necessary.
c. Select the Start Client check box, if necessary.
d. Click Finish.
After all of the services are started, the Log In dialog box displays.
To make changes to the configuration, you can re-launch the configuration wizard (refer to
“Configuring an explicit server IP address” on page 36).
15. Enter your user name and password.
The defaults are Administrator and password, respectively. If you migrated from a previous
release, your user name and password do not change.
NOTE
Do not enter Domain\User_Name in the User ID field for LDAP server authentication.
16. Click Login.
17. Click OK on the Network Advisor Login Banner.
Cross flavor migration
To migrate from IBM Network Advisor 12.0.X to a IBM Network Advisor 12.3.X, complete the
following steps.
1. Install IBM Network Advisor 12.0.X (refer to “Installing the application” on page 10).
2. Install IBM Network Advisor 12.3.X (refer to “Installing the application” on page 10).
3. Migrate the supported (partial or full) data from IBM Network Advisor 12.0.X (refer to
“Migrating data” on page 46) to the IBM Network Advisor 12.3.X by browsing to the Network
Advisor 12.3.X location on the Copy Data and Setting screen.