Technical data

Brocade Network Advisor SAN Installation and Migration Guide 21
53-1003580-01
Configuring Network Advisor
2
9. Complete the following steps on the Server Configuration screen (Figure 1).
FIGURE 1 Server Configuration screen
a. Enter a port number in the Web Server Port # (HTTPS) field (default is 443).
b. Enable HTTP redirection to HTTPS by selecting the Redirect HTTP Requests to HTTPS
check box.
When you enable HTTP redirection, the server uses port 80 to redirect HTTP requests to
HTTPS. You can configure the server port settings from the Options dialog box (Server Port
pane). For instructions, refer to the Network Advisor User Manual or online help.
c. Enter a port number in the Database Port # field (default is 5432).
NOTE
Do not use a port number below 1024.
d. Enter a port number in the Starting Port Number field (default is 24600).
NOTE
For Trial and Licensed software, the server requires 11 consecutive free ports beginning
with the starting port number.
e. Enter a port number in the Syslog Port Number field (default is 514).
NOTE
If the default syslog port number is already in use, you will not receive any syslog
messages from the device. To find and stop the process currently running on the default
Syslog port number, refer to “Syslog troubleshooting” on page 27.
f. Enter a port number in the SNMP Port Number field (default is 162).
g. Enter a port number in the TFTP Port Number field (default is 69).
h. Click Next.
If you enter a syslog port number already in use, a message displays. Click No on the
message to remain on the Server Configuration screen and edit the syslog port number.
Click Yes to close the message.
If you enter a port number already in use, a Warning displays next to the associated port
number field. Edit that port number and click Next.