Installation guide

If any of the named devices are OS files rather than raw partitions, use the appropriate OS commands to

remove those files.

4. Remove all files that were returned in the <d.phyname> list.

Note

File names cannot be complete path names. If you use relative paths, they are relative to the directory from

which your server was started.

5. Find another existing device that meets the requirements for additional free space, or use a disk init

command similar to the following to create an additional device for sybsystemprocs, where /sybase/

work/ is the full, absolute path to your system procedures device:

1> use master

2> go

1> disk init

2> name = "sysprocsdev",

3> physname = "/sybase/work/sysproc.dat",

4> size = 200M

5> go

Note

Server versions 12.0.x and later accept, but do not require "vdevno=number". For information about

determining whether

vdevno is available, see the System Administration Guide.

The size you provide should be the number of megabytes of space needed for the device, multiplied by 512.

disk init requires the size to be specified in 2KB pages. In this example, the size is 112MB (112 x 512 =

57344). For more information on disk init, see the Reference Manual: Commands.

6. Create a sybsystemprocs database of the appropriate size on that device, for example:

1> create database sybsystemprocs on sysprocsdev = 180

2> go

7. In the old server installation directory, enter:

isql -Usa -P<password> -S<server_name >-i$SYBASE/ASE-15_0/scripts/installmaster

Installation Guide for Linux

SAP ASE Upgrades