System information

50 Deploying Samba on IBM Eserver BladeCenter
– Time zone: Click Time zone to modify the default time zone for the installation. Select
the correct time zone from the list. Under the Hardware clock set to section, select
either local time or UTC, as appropriate. Click Accept.
– Language: Click Language to modify the default language for the installation. Select
the needed language from the list and click Accept.
6. If all Installation Settings are to your preference, click Accept and click Yes, install at the
Warning window.
7. You will be asked to insert the 'UnitedLinux Version 1.0' CD 1. Do so and click OK.
8. Later in the installation process, you will be asked to insert additional CDs to finish
installing the packages. You will need the 'UnitedLinux Version 1.0' CD 2 and the 'SuSE
SLES Version 8' CD1.
9. When all packages are installed, the installer will run some post installation scripts and
then reboot into the final installer section on the hard disk. Remove any CDs from the
CD-ROM drive as the prompt indicates and press Enter.
10.At the
Password for 'root', the system administrator window, type the administrative
password that you want twice and click Next.
Figure 3-15 SLES Installation - Adding new users
11.At the Add a New User window, type the information for one system user. You can also
add additional users and groups or change the password settings by clicking the
appropriate buttons to do so. When finished, click Next.
Note: In our case, the mouse did not work in the next steps of the installation process.
We had to use keyboard navigation.
Note: You need to add at least one user to let the installation continue.