System information

34 Deploying Samba on IBM Eserver BladeCenter
9. Select Use GRUB as the boot loader, /dev/hda Master Boot Record (MBR), Default
boot image, and click Next.
10.Do not select Use a GRUB Password; click Next.
11.On eth0 page, deselect Activate on boot, click the eth1 tab, select Configure using
DHCP, select Activate on boot, and click Next.
12.Follow the Red Hat Linux 7.3 install instructions at:
http://www.redhat.com/docs/manuals/linux/RHL-7.3-Manual/install-guide/s1-firewallconfig.
html
to finish the install setup process.
Figure 3-7 Boot Disk Creation.
13.Select Skip boot disk creation and click Next.
A boot diskette can be created with mkbootdisk after the diskette drive is defined, as
shown in Step 17 on page 35.
14.Follow the Red Hat Linux 7.3 install instructions at:
http://www.redhat.com/docs/manuals/linux/RHL-7.3-Manual/install-guide/s1-xconfig.html
to finish the install. We selected the following software groups.
– Printing Support
– Classic XWindow System
– X Window System
–GNOME
–KDE
– Network Support
– Network Managed Workstation