Installation guide

Install the Web Agent on a UNIX System
Chapter 3: Install a Web Agent on a UNIX System 59
Run an Unattended Installation on UNIX
You should have completed an initial Web Agent installation and, if necessary,
modified the ca-wa-installer.properties file. Now, you can use the file to run
subsequent Web Agent installations.
To run an unattended Web Agent installation
1. From a system where the Web Agent is already installed, copy the following
files to a local directory:
a. ca-wa-version-operating_system.bin (Agent executable) from where it
resides on your system.
b. Copy the ca-wa-installer.properties file from
web_agent_home/install_config_info.
2. Open a console window and navigate to the directory where you copied the
two files.
3. Run the installation executable with the -f and - i silent options, as follows:
agent_binary -f properties_file -i silent
Note: If you are not at the directory where these files reside, you must
specify the full path to each file.
Assuming that you run the installation from the directory where the
executable and properties file are located, the command would be:
./ca-wa-version-operating_system.bin -f ca-wa-installer.properties
-i silent
When the installation is complete, you return to the command prompt.
4. CA_SiteMinder_Web_Agent _version_InstallLog.log file, located in the
web_agent_home/install_config_info directory. This log file contains the
results of the installation.
5. Register the trusted host and configure the Web Agent.
More Information
How to Configure Any Web Agent in Unattended Mode (see page 145)
Stop an Unattended Installation in Progress on UNIX
To manually stop the installation, press Ctrl + C.