Installation guide

How to Configure Any Web Agent in Unattended Mode
146 Web Agent Installation Guide
Prepare an Unattended Configuration
Unattended configuration uses the ca-wa-installer.properties file to propagate
the Web Agent configuration set up across all Agents in your network. For
configuration, you define configuration parameters in the properties file, then
copy the file to any web server in your network to run an unattended
configuration.
When you perform an initial Web Agent installation and configuration, the
ca-wa-installer.properties file is installed in the following location:
web_agent_home/install_config_info
The default parameters and paths in the file reflect the information you entered
during the initial Web Agent installation and configuration.
To make the ca-wa-installer.properties file available on your system
1. Run an initial installation of the Web Agent.
2. Open the ca-wa-installer.properties file and, if necessary, modify the
configuration parameters.
3. Save the file.
More Information
Install a Web Agent on a UNIX System (see page 51)
Install a Web Agent on a Windows System (see page 31)
Run an Unattended Configuration
Before you run an unattended configuration, you should have completed the
following tasks:
■
an initial (attended) Web Agent installation
■
an initial (attended) Web Agent configuration
■
modification of the ca-wa-installer.properties file
You use this file to run subsequent unattended Web Agent configurations
■
an installation (attended or unattended) on the system where you want to
run the unattended configuration. This installation makes the configuration
executable available.