Installation guide

Component 12.5.4 Loca-
tion
15.0.2 Loca-
tion
15.0.3 Loca-
tion
15.5, 15.7, and
15.7 ESD #1
and ESD #2 Lo-
cations
Job Scheduler
$SYBASE/
JS-12_5
$SYBASE/
ASE-15_0/
jobschedu-
ler
$SYBASE/
ASE-15_0/
jobschedu-
ler
$SYBASE/
ASE-15_0/
jobschedu-
ler
Unified Agent
$SYBASE/
UAF-2_0
$SYBASE/
UAF-2_0
$SYBASE/
UAF-2_5
In Adaptive Server
15.7 ESD #1 and
later, UAF-2_5 is
placed with
SCC-3_2 for the
Sybase Control
Center.
Performing Preupgrade Tasks
To ensure a successful upgrade, review and perform the preupgrade tasks as necessary.
Depending on the old server configuration, you may not need to perform all preupgrade tasks.
Prerequisites
• You need the master and system procedures files to upgrade the server. By default, the
master (master.dat) and system procedures device (sybsytemprocs.dat) files
are installed in the $SYBASE/data directory.
• The previously installed version of the server must be running. If you are upgrading
Backup Server, Historical Server, or XP Server, those servers must not be running.
Task
1.
Install Adaptive Server 15.7 ESD #2 into its own installation directory.
2.
Check system and upgrade requirements.
3.
Ensure that the directory to which your TEMP environment variable points exists. The
installation program uses this directory to write files temporarily during the installation,
which it locates through the TEMP environment variable.
4.
Verify the name and location of the runserver file, as well as that you renamed it to
RUN_servername, where servername is the name of the old server, as it appears in the
interfaces file.
CHAPTER 10: Adaptive Server Upgrades
74 Adaptive Server Enterprise