Specifications

Disks and Units
74 SnapServer Administrator Guide
Replacing a Disk Drive on the SnapServer 4200, 4500, or Snap Disk 10
When the drive’s power LED is amber and the activity LED is off, the disk drive has
failed or is not working correctly.
1 Remove the front bezel. With a hand on each
latch, slide both latches on the front bezel
toward the center. While holding the latch in
the release position, pull the bezel away from
the chassis.
2 On the closed handle of the failed disk drive,
press the latch to the right.
3 To remove the failed disk drive, pull its
handle.
4 Release the latch on the new disk drive and open its handle. If the handle is
closed, you cannot insert the disk drive completely into the bay.
5 Insert the new disk drive. Make sure you push it forward completely before you
press the handle into place.
6 Replace the front bezel.
Replacing a Disk Drive on the SnapServer 18000
When the status LED is amber and the activity LED is off, the drive has failed or is
not working properly.
1 Open the font panel.
2 Remove the failed disk drive by pressing the latch on the handle of the drive and
pulling the handle.