Specifications

The Meaning of LED Indicators
Appendix C Troubleshooting SnapServers 187
Overland Storage recommends that you become familiar with the operation of these
lights.
Power, System, and LAN LEDs
These status lights are located to the right of the power button. Looking at the
server from the front, the lights appear in the following order, from left to right:
power LED, system LED, LAN 1 (Ethernet1) LED, and LAN 2 (Ethernet2) LED. The
Disk Drive LEDs run along the bottom of the bezel, two LEDs for each disk drive.
The LEDs operate as described in the following tables:
Disk Drive LEDs
Disk drive LEDs are located along the bottom of the bezel, two LEDs for each drive.
For all disk drive LEDs, the left light indicates drive status; the right light indicates
drive activity. They operate as follows:
Power LED
Solid green The server is powered on.
Off The server is powered off.
System LED
Blinking green The server is operating normally.
Blinking amber A thermal or other system problem was detected.
Blinking amber and
green
The server is in Maintenance Mode.
LAN 1 and LAN 2 LEDs
Solid green The server is active and connected to the network.
Off The port is disconnected or the Ethernet cable is not
connected or linked to an active switch.
Status LED (left) Activity LED (right)
Off Off Drive is not present.
Solid green Blinking green Disk drive installed properly and is active
Solid amber Off Disk drive installed, but not working
correctly