User guide

Environment Setting for EJB Service
11-3
Environment Setting for EJB Service
When using SSL linkage, use the Interstage Management Console to set encrypted communication
using SSL.
This setup is the same as for an application using SSL in CORBA Service. For details, refer to
Chapter10, How to Use SSL with the CORBA Service.
Web-J Edition supports only the client function of the Interstage EJB service.
Steps specific to EJB Service are as follows:
Set/Unset the Encryption Communication Using the SSL Protocol
Use the Interstage Management Console to set and reset encrypted communication that uses SSL.
• Setting
Define the EJB container of the IJServer WorkUnit that uses SSL in the window of the Interstage
Management Console as follows.
− From the Interstage Management Console, select [WorkUnit] | [IJServer name] | [Environment
setup] | [EJB container setting].
− Specify "Enable" for [Enable/disable SSL for IIOP communication].
• Unsetting
Define the EJB container of the IJServer WorkUnit that uses SSL in the window of the Interstage
Management Console as follows.
− From the Interstage Management Console, select [WorkUnit] | [IJServer name] | [Environment
setup] | [EJB container setting].
− Specify "Disable" for [Enable/disable SSL for IIOP communication].
Note
SSL can only be used for IIOP communication when one of the following WorkUnit types applies.
• The Web application and EJB application run on different JavaVMs.
• Only an EJB application runs.
If the value for config (UNO_IIOP_ssl_port) in the CORBA Service is changed after setting up SSL
communication, the EJB application must be redeployed.
When HTTP tunneling is performed using SSL communication, the start parameter must be specified
when the client application starts.
For more information, refer to Chapter 5, HTTP Tunneling of J2EE.
HTTP tunneling can be used with the following products:
• Interstage Application Server Enterprise Edition
• Interstage Application Server Standard Edition