User guide

SSL Environment Setup in Client
10-7
SSL Environment Setup in Client
To use an Interstage certificate environment, set an SSL environment using the Interstage management
console. The following is the procedure for setting an environment that enables CORBA clients to use
SSL in a certificate/key management environment configured with the SMEE commands.
1. Create a certificate/key management environment.
For details, refer to Creating a Certificate/Key Management Environment in Chapter 7.
2. Create a secret key and acquire a certificate.
For details, refer to Creating a Secret Key and Acquiring a Certificate in Chapter 7.
3. Register the certificate and CRL.
For details, refer to Registering the Certificate and CRL in Chapter 7.
4. Define a private key/certificate in the CORBA Service.
5. Edit the config file.
The following sections explain the steps 4 and 5 for CORBA client.
Note
To set up the SSL environment, use the following commands:
To use a parameter that is too long to enter at the command prompt, include the parameter in a batch
file for execution.
Table 10-1 Client SSL Setup Commands
Command Definition
C:\Interstage\ODWIN\bin\odsetSSL Defines private key/certificate for CORBA Service.
Defining a Private Key/Certificate in CORBA Service
To perform SSL communication via CORBA application linkage, define a private key/certificate in the
CORBA Service.
Defining Private Key/Certificate
To define a private key/certificate in the CORBA Service, execute the odsetSSL command.
If the site certificate (client certificate) of the local host is used, specify the nickname of the site
certificate. When the command is executed, input the user PIN set in the token.