Service manual

Installation
40 Sun ONE Directory Server Installation and Tuning Guide • June 2003
1. Log on as a user with Administrator privileges.
2. Start the installation program with the -saveState option.
From the folder where you unpacked the product, enter
Prompt>setup -saveState filename
to create the specification file, filename.
3. Perform interactive installation.
4. Adjust the specification file, filename, before using it to install on other systems.
Some silent installation specification file directives, such as
FullMachineName,
depend directly on the underlying host system and so cannot be generated
generically.
Silent installation specification files contain a checksum string corresponding tothe
build version of the install program. To reuse a silent installation specification file
with a differentbuild or release of the install program,update the checksum string
in lines beginning with
[STATE_BEGIN and [STATE_DONE. The updated checksum
can be found in
typical.ins. Code Example 1-1 on page 30 shows a sample
checksum.
Installing Using the Specification Files
1. Verify the changes made to the installation specification file.
2. Start the installation program in silent mode.
From the folder where you unpacked the product, enter
Prompt>setup -noconsole -nodisplay -state filename
Here filename is the silent installation specification file.
Completing the Installation Process
1. Ensure that access permissions for files under ServerRoot\alias have been set
to prevent access by all users other than servers you install under ServerRoot.
2. After installation, manually set special access permissions for the following
files such that only the user and group running the Administration Server has
read-write access, and all other users have no access.
❍ ServerRoot\admin-serv\config\adm.conf
❍ ServerRoot\admin-serv\config\admpw
❍ ServerRoot\admin-serv\config\magnus.conf