Service manual

Installation
36 Sun ONE Directory Server Installation and Tuning Guide • June 2003
5. Before installing using a locale other than US English, set the LANG
environment variable to C.
Additional Instructions For AIX Systems
If you plan to use the Console, install the X11.adt package.
This package is not part of the standard bundle, but may be obtained from
IBM.
Additional Instructions For HP-UX Systems
1. Ensure that support for IPv6 is installed, evenif you do not intend to use IPv6
interfaces with Directory Server.
2. Before installing remotely using a locale with fonts not supported for US
English, ensure you can access font aliases for remote sessions.
Refer to the operating system documentation forinstructions.
Performing Interactive Installation
1. Start the installation program in the directory containing the unpacked
software.
For the graphical user interface:
root# ./setup
For the command-line interface:
root# ./setup -nodisplay
The first installation screen appears.
2. Follow the instructions on each screen using the work sheet you made when
“Preparing Installation Information,” on page 21.
Do not install this versionin the same directory as an earlier version of the
Directory Server.If you must reuse the same directory location, first uninstall
the earlier version. Refer to Chapter 2, “Upgrading From Previous Versions,”
for further information.
NOTE To install a 32-bit Directory Server on platforms with 64-bit server
support, ensure you clear the check box next to Sun ONE Directory
Suite > Sun ONE Directory Server (64-bit support) in the wizard
screen titled
Select Components.