Service manual

171
Appendix C
Installing Sun Cluster HA for
Directory Server
This appendix describes how to install and configure both the Sun Cluster HA for
Directory Server data service and the associated Administration Server data
service. Refer to the Sun Cluster 3.0 product documentation for Sun Cluster
installation instructions and key concepts.
Youmustconfigurethedataservicesasafailoverservices.
Before You Start
Use this section in conjunction with the worksheets in the Sun Cluster 3.0 Release
Notes as a checklist before performing installation and configuration.
Prior to starting your installation, consider these questions.
• Do you plan to run multiple Directory Server instances on the same node?
If so, you may choose to set
nsslapd-listenhost on cn=config to the
appropriate networkresource (a logical host name, such as
dirserv.example.com) as the IP address for each instance. Directory Server
default behavior is to listen on all network interfaces.
• Do you run multiple data services in your Sun Cluster configuration?
You may set up multiple data services in any order, with one exception: If you
use Sun Cluster HA for DNS, you must set it up before setting up Sun Cluster
HA for Directory Server.
Table C-1 summarizes the Sun Cluster HA for Directory Server installation and
configuration process.