Installation guide

NOTE
To register the Directory Server instance with an existing Configuration Directory Server,
select yes. T his continues with the registration process rather than the regular express
setup process.
Registering a new instance with a Configuration Directory Server requires you to supply
information about the Configuration Directory Server:
The Configuration Directory Server URL, such as
ldap://ldap.exam ple.com :389/o=NetscapeRoot
To use T LS/SSL, set the protocol as ldaps:// instead of ldap:// For LDAPS, use
the secure port (636) instead of the standard port (389), and provide a CA certificate.
The Configuration Directory Server administrator's user ID; by default, this is adm in.
The administrator user's password.
The Configuration Directory Server Admin domain, such as example.com .
The CA certificate to authenticate to the Configuration Directory Server. This is only
required if the Directory Server instance will connect to the Configuration Directory
Server over LDAPS. This should be the full path and filename the CA certificate in
PEM/ASCII format.
This information is supplied in place of creating an admin user for the new Directory Server
in steps 6 and 7.
6. Set the administrator username. T he default is adm in.
7. Set the administrator password and confirm it.
8. Set the Directory Manager username. T he default is cn=Directory Manager.
9. Set the Directory Manager password and confirm it.
10. T he last screen asks if you are ready to set up your servers. Select yes.
Are you ready to set up your servers? [yes]:
Creating directory server . . .
Your new DS instance 'example' was successfully created.
Creating the configuration directory server . . .
Beginning Admin Server reconfiguration . . .
Creating Adm in Server files and directories . . .
Updating adm.conf . . .
Updating admpw . . .
Registering admin server with the configuration directory server . . .
Updating adm.conf with information from configuration directory server . . .
Updating the configuration for the httpd engine . . .
Restarting admin server . . .
The admin server was successfully started.
Admin server was successfully reconfigured and started.
Exiting . . .
Log file is '/tmp/setup0C7tiV.log'
The setup-ds-adm in.pl script applies all default options for the Directory Server configuration,
including the instance name (for example, ldap.exam ple.com ), domain (for example,
exam ple.com ), suffix (for example, dc=example, dc=com ), and port numbers (389 for the Directory
Server instance and 9830 for the Administration Server).
When the setup-ds-adm in.pl script is done, then the Directory Server is configured and running. To
log into the Directory Server Console to begin setting up your directory service, do the following:
Chapter 4. Setting up Red Hat Directory Server on HP-UX 11i
4 9