Installation guide

NOTE
Directory Server 8.0 requires JRE version 1.5.0.
Download the JRE from http://www.hp.com/products1/unix/java/, and install it according to the HP Java
instructions.
After installing the JRE, install the Directory Server packages, as described in Section 4.2, “Installing the
Directory Server Packages”.
4.2. Installing the Directory Server Packages
The Directory Server packages for HP-UX 11i are included in an SD package which can be downloaded
from HP.
For complete instructions on installing the Red Hat Directory Server packages on HP-UX, see the HP-
specific release notes at
http://docs.hp.com/en/internet.html#Netscape%20Directory%20Server/Red%20Hat%20Directory%20Ser
ver. After the Directory Server packages are installed, run the setup program to set up and configure
the default Directory Server instance and the Administration Server.
/opt/dirsrv/sbin/setup-ds-admin.pl
Accept the initial screens for licensing and dsktune output, then select the setup type, and proceed with
configuring the new Directory Server instance.
Section 4.3, “Express Setup”
Section 4.4, “T ypical Setup”
Section 4.5, “Custom Setup”
NOTE
Directory Server version 8.0 conforms to the Filesystem Hierarchy Standards. T his means that
the directories and files are in different locations than previous versions. For more information on
FHS, see the http://www.pathname.com/fhs/ homepage. For a table showing the new file locations,
see Section 7.1, “Directory Server File Locations”.
4.3. Express Setup
Use express installation if you are installing Directory Server for an evaluation or trial. Because express
installation does not offer the choice of selecting the Directory Server server port number or the directory
suffix, among other settings, Red Hat recommends not using it for production deployments.
Chapter 4. Setting up Red Hat Directory Server on HP-UX 11i
4 7