Installation guide

Installing Any Agent from the Command Line
72 Sun ONE Identity Server Policy Agents 2.1 • Web Policy Agents Guide • September 2004
• Configure the filter for each of the server partitions you want to support.
You canconfigure the filter for the different partitions by performing the following
steps:
1. In Lotus Domino Administrator, choose Administrator Tab > Server > All
Server Documents.
2. From the listed servers, select the required server.
3. Now go to Internet Protocols > HTTP.
4. At the DSAPI Filter File names field, enter the following:
Agent_Install_Dir\domino\bin\amdomino6.dll
If youinstalling the agent for Lotus Domino 5, enter the DSAPI Filter file name
as follows:
Agent_Install_Dir\domino\bin\amdomino.dll
5. Save the changes and close the window.
6. Open Domino console and restart the server by entering the following
commands:
tell http quit
load http
Installing Any Agent from the Command Line
In addition to the GUI mode of installation, the installation program also offers a
command-lineinterfacefor installing an agent. The command-lineinterface applies
to all agents, Installation Type I and Installation Type II agents. However,
configuration is still necessary for Lotus Domino 5 and 6 amongst the Installation
Type I agents and for both the Installation Type II agents.
Use the following steps to install the agent from the command-line.
1. In the directory where you unzipped the binaries, at the command line, enter
the following command:
# setup.exe -nodisplay