Installation guide

Installing and Configuring the Installation Type I Agents
Chapter 3 Policy Agents on Microsoft Windows 71
12. When the installation is complete, you can click Details to view details about
the installation, or click Close to end the installation program.
13. Restart your computer.
Restarting your computer is necessary for the agent to work properly. The
installation modifies the system path by appending to it the location of the
agent libraries. This change takes effect only after your computer is restarted.
Configuration is only necessary for Lotus Domino 5 and 6. You must configure the
Domino DSAPI filter as explained in “Configuring the Domino DSAPI Filter” on
page 71.
Configuring the Domino DSAPI Filter
The policy agent for Lotus Domino supports Domino versions 5.0 and 6.0. When
configuring theDSAPI filter, you must direct the policy agent touse the DSAPI file
filter appropriate to the version of Domino you are attempting to protect. Use the
following procedure to configure the Domino DSAPI filter.
1. In Lotus Domino Administrator, choose Administrator Tab > Server > All
Server Documents.
2. From the listed servers, select the server you want to configure.
3. Click Internet Protocols > HTTP tab.
4. At the DSAPI Filter File names field, enter
Agent_Install_Dir\domino\bin\amdomino6.dll
If youinstalling the agent for Lotus Domino 5, enter the DSAPI Filter file name
as Agent_Install_Dir\domino\bin\amdomino.dll.
5. Save the changes and close the window.
6. Open Domino console and restart the server by entering the following
commands:
tell http quit
load http
Configuring Domino DSAPI Filter for Multiple Server Partitions
If you are configuring Domino DSAPI Filter for multiple server partitions, you
must:
• Use the same AMAgent.properties file for all the supported partitions.