Installation guide

Installing the Agent
38 Sun ONE Identity Server Policy Agents 2.1 • Web Policy Agents Guide • April 2005
Failover Server Port: Enter the port number of the secondary web server that
runs Sun ONE Identity Server. If no failover host exists, then leave this field
blank.
Failover Server Deployment URI: Enter the location that was specified when
Sun ONE Identity Server was installed. The default URI for Sun ONE Identity
Server is
/amserver.
Failover Console Deployment URI: Enter the locationthatwasspecifiedwhen
Sun ONE Identity Server console was installed. The default URI for Sun ONE
Identity Server is /amconsole.
Agent Identity Server Shared Secret: Enter the password for the Identity
Server internal LDAP authentication user.
Re-enter Shared secret: Re-enter the password for the Identity Server internal
LDAP authentication user.
CDSSO Enabled: Check this box if you want to enable CDSSO.
9. When all the information is entered correctly, click Next.
10. Review the Installation Summary to be sure that the information you’ve
entered is correct. Note that it displays the CDCServlet URL if you have
checked the CDSSO Enabled box in the previous panel. If you want to make
changes, click Back. If all the information is correct, click Next.
11. In the Ready to Install page, click Install Now.
12. When the installation is complete, you can click Details to view details about
the installation, or click Exit to end the Installation program.
13. Restart the Proxy Server.
Installing From the Command Line
The following sections describe how to use the CLI of the installation program to
install the web policy agents.
Installing the Policy Agent for a Web Server
1. In the directory where you unpacked the binaries, at the command line, enter
the following:
# setup -nodisplay