Installation guide

Installing the Agent
Chapter 2 Policy Agents on Solaris and HP-UX 37
5. To search for the directory where you would like to install the agent, click
Browse. To accept the default, click Next.
6. When prompted, provide the following information about the web proxy
server where this agent will be installed:
Host Name: Enter the FQDN of the system where the remote web server is
installed. For example, mycomputer.example.com.
Proxy Server Instance Directory: Enter the full path to the directory where the
Sun ONE Web Proxy Server instance is located. For example:
proxy_server_root_dir/proxy-mycomputer-proxy
Proxy Server Port: Enter the port number for the Proxy server instance.
Proxy Server Protocol: If the proxy server has been configured for SSL, choose
HTTPS; otherwise choose HTTP.
Agent Deployment URI:Enter a directoryname.The default URIis
/amagent.
7. When all the information is entered correctly, click Next.
8. When prompted, provide the following information about the web server that
runs Sun ONE Identity Server.
Primary Server Host: Enter the FQDN of the system where the primary web
server that runs Sun ONE Identity Server is installed. For example,
myserver.example.com.
Primary Server Port: Enter the port number for the web server that runs Sun
ONE Identity Server.
Primary Server Protocol: If the web server that runs Sun ONE Identity Server
is SSL-enabled, select HTTPS; otherwise select HTTP.
Primary Server Deployment URI: Enter the location that was specified when
Sun ONE Identity Server was installed. The default URI for Sun ONE Identity
Server is /amserver.
Primary Console Deployment URI:Enterthelocation that wasspecifiedwhen
Sun ONE Identity Server console was installed. The default URI for Sun ONE
Identity Server is /amconsole.
Failover Server Host: Enter the FQDN for the secondary web server that will
run Sun ONEIdentity Server ifthe primary webserverbecomes unavailable.If
no failover host exists, then leave this field blank.